Related Manuals for Blackstar 200
Summary of Contents for Blackstar 200
- Page 1 Owner’s Manual Designed and Engineered by Blackstar Amplification UK...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. - Page 3 ½ ¼ or less Unauthorised modification of this equipment is expressly forbidden by Blackstar Amplification Ltd. According to OSHA, any exposure in excess of the above permissible limits could Never push objects of any kind into ventilation slots on the equipment casing.
- Page 4 This is a result of If you like what you hear and want to find out more about the Blackstar range of unique preamplifier and power amplifier shaping techniques, which also benefit the products please visit our website at www.blackstaramps.com.
-
Page 5: Front Panel
Front Panel 8. Crunch Select Press this switch to select the Crunch Channel. 1. Input 9. Crunch Gain Plug your guitar in here. Always use a good quality screened guitar lead. The Crunch Gain control adjusts the amount of the Crunch Channel’s overdrive or Clean Channel distortion. - Page 6 28. Resonance 21. Overdrive 2 Select The Resonance control sets the overall bass response of the S1-200. At lower Press this switch to select the Overdrive 2 Channel. settings the cleans will be tight and funky and overdrives will be focussed in their bass response.
- Page 7 31. DPR (Dynamic Power Reduction) Crunch DPR Operation The DPR control allows the output power of the S1-200 to be reduced anywhere The DPR control allows you to pin-point exactly how much valve overdrive you want from 200W (100%) down to 20W (10%) of the rated power.
- Page 8 MIDI Channel Switching Program Change Assignment The Series One offers the ability to control channel selection via MIDI Program To change the default assignments and set the amp up to respond to a different set Change messages and interfacing with most MIDI controllers is a straight forward of Program Changes: process.
-
Page 9: Rear Panel
CONNECT SPEAKERS BEFORE USE This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two OUTPUT: 200 WATTS RMS conditions: (1) this device may not cause harmful interference, and (2) this device must accept T1AL 250V F1A 250V any interference received, including interference that may cause undesired operation. - Page 10 8. Impedance Selector Technical Specification This control matches the amplifier’s impedance to that of the connected speakers. Power (RMS): 200 Watts Always ensure that the selected impedance matches that of the speaker cabinets connected. See table below. Valves: 4 x KT88, 4 x ECC83, 1 x ECC82...
- Page 11 Manufacturer: Blackstar Amplification Date: 18-03-09 Model: Series One Version: 1.0 +------------------------------------------------------------------------+ Transmitted Recognized Remarks Function ... :---------------------+-----------------+----------------+---------------: :Basic Default : Omni :Channel Changed : 01-07 :---------------------+-----------------+----------------+---------------: :Mode Default Messages Altered :---------------------+-----------------+----------------+---------------: :Note :Number True Voice :---------------------+-----------------+----------------+---------------: :Velocity Note On Note Off...
- Page 12 For the latest information go to: www.blackstaramps.com Whilst the information contained herein is correct at the time of publication, due to our policy of constant improvement and development, Blackstar Amplification Ltd reserves the right to alter specifications without prior notice.
Need help?
Do you have a question about the 200 and is the answer not in the manual?
Questions and answers