Advertisement
2. Installation procedure 【Applicable model : Group B】
●To protect the wires connected to M-NET board from the edges of
sheet-metal component, paste the insulation on the edge surface of panel
sheet-metal before proceeding with the following work.
1
Paste insulation sheet ③ on sheet-metal so that it
completely envelops the edge surface of sheet-metal.
(When viewed from the side of Electric box）
①M-NET board
2
Control board
(When viewed from the side of Electric parts box）
L
N
S1 S2 S3
M-NET Converter PAC-SF81MA-E
7
3
CENTRALIZED CONTROL(M-NET)
4
Ａ
Ｂ
Ｓ
Ｂ Ｇ ７ ９ Ｈ ７ ４ ４ Ｈ ０ ２
1
Pate insulation sheet ③ on sheet-metal
so that it completely envelops the edge
surface of sheet-metal.
Install M-NET board ① (with insulation
2
sheets and supports) on the side of
Electric box so that the rotary switch
faces up (at the four points indicated by
arrows).
※Push it firmly until you hear it
click .
Use terminal screw ⑦ to secure terminal
3
block⑥
※Terminal block⑥ has a round boss for
positioning:Fit the round boss into the
positioning hole in steel-plate.
Paste label ⑧ under terminal block ⑥
4
Use lead wire-A ⑨ to connect CN5 of
5
M-NET board ① connection and
CNMNT of outdoor control board.
※Caution
Wire Marking:INV type, Connector
color:Red Always make sure that the
markings and the applicable model
match. If used incorrectly, parts could
be damaged.
Use lead wire-C ⑪ to connect CND of
6
M-NET board ① connection and
CNVMNT of outdoor control board.
Use lead wire-D ⑫ to connect CN2M of
7
M-NET board ① connection and
terminals A and B of terminal block ⑥
Polarity is not a concern.
※Connect the wire firmly making sure
that the screws on terminal block are
not loose.
The lead wires should be tied together
8
with the other lead wires with
the pull tight ⑭ not to loose.
Wiring length is adjusted according to
apparatus.
It progresses to the page
3.Wiring method for M-NET
Note1:Use ground wire and screw ⑬ as
required to connect the shield of
M-NET transmission line to the unit.
Note2:Take great care that no lead wire is
caught on anything when instaling
panels.
E-213
Advertisement
