Operation - Dometic Coolfreeze Series Operating Manual

CoolFreeze
6

Operation

The cooling device is equipped with an LED interior light that remains on when the
voltage is applied. The energy consumption of the LED interior light is extremely low
and is negligible compared to the total energy consumption of the device.
6.1 Before initial use
I
NOTE
Before starting your new cooler for the first time, you should clean it
inside and outside with a damp cloth for hygienic reasons (see also
chapter "Cleaning and maintenance" on page 16).
6.2 Energy saving tips
•
Choose a well ventilated location which is protected from direct sunlight.
•
Allow warm food to cool down first before placing it in the device to keep cool.
•
Do not open the cooling device more often than necessary.
•
Do not leave the lid open for longer than necessary.
•
Defrost the cooling device as soon as a layer of ice forms.
•
Avoid unnecessarily low temperature settings.
6.3 Locking the cooling device
➤ Close the lid.
➤ Press the latch (fig. 3 1, page 3) down, until it latches in place audibly.
6.4 Connecting the cooling device
Connection to the DC socket
I
NOTE
If you connect the cooler to the DC socket, remember that the ignition
must be turned on to supply it with power.
➤ Place the cooler on a firm base.
Make sure that the ventilation slots are not covered and that the heated air can be
dissipated.
➤ Connect the 12/24 V connection cable to the DC socket in the vehicle.
EN
Operation
11