Memory Settings; Selection Button Type Of Welding Current - Sherman digitec DIGITIG 200AC / DC MULTIPRO User Manual

E - Memory settings
The device has a memory of the last setting, ie after switching off and then return to the last set parameters. You can also store a total of 20
sets of settings for TIG HF and MMA.
To recall previously saved set of settings, press the button
the corresponding number set in the display memory (H).
If the call connection set we change any of the parameters, the device will exit the memory - the display memory (H) will be extinguished and the LED
line line line The changed parameters are stored automatically after 30 seconds in the cache. After the device is turned off and restarted, they will be The changed parameters are stored automatically after 30 seconds in the cache. After the device is turned off and restarted, they will be The changed parameters are stored automatically after 30 seconds in the cache. After the device is turned off and restarted, they will be
USER. USER. USER.
restored and the display memory will appear dash.
To save the current settings, press the button
diode diode diode and the number on the display memory (H) flashes. Turn the knob will change and the number on the display memory (H) flashes. Turn the knob will change and the number on the display memory (H) flashes. Turn the knob will change
USER USER USER
set number. Pressing the button again
setting the currently selected number. If the 10 seconds will not happen again, the machine will return to the main menu.
If the device is turned off, the memory is loaded set of parameters after restart automatically loaded last used will be set, and the number will appear
on the display. If the memory is not loaded any set of parameters and the device is turned off, the next time you turn on the most recently used will
be restored and the display parameters (H) appears in the dash.
F - selection button type of welding current (AC / DC)
Pressing the button changes the type of welding current. Choosing the type of current is confirmed
lighting up the symbol. lighting up the symbol. lighting up the symbol. lighting up the symbol. lighting up the symbol. - alternating current, - alternating current, - alternating current, - alternating current, - alternating current,
AC AC AC AC AC
G - selection button waveform AC
Button allows a choice of the waveform during the TIG welding, or TIG HF Lift:
sine wave: Classical wave, similar to the welding transformer, favored by older welders.
square wave: Universal, the most widely used welding waveform for each material. Generates more heat in the weld zone, a greater
penetration than the other forms.
trapezoidal wave: The softer arc with liquid lake and good wetting of the material. Better control of arc than the sine wave.
Triangular wave: Preferred especially when welding thin materials.
within 10 seconds will save the current within 10 seconds will save the current
- DC - DC - DC - DC - DC
DC DC DC DC DC
9
until you see
and hold two seconds. lights