Arc Initiation And Conduct Of Tig Welding Lift; Tig Welding In 2T - Sherman digitec DIGITIG 200AC / DC MULTIPRO User Manual

welding the lead button is pressed. Releasing the button on the handle causes the start of the current phase of descent and ending the welding
process.
To ignite the arc mode czterotaktu must approach the electrode to the workpiece at the distance of 2 millimeters and press the button on the handle of
the torch to turn the ionizer. After the correct arc is lit button can be released and welding lead to the slow button. To complete the welding press again
and release the button on the handle.

10.2.2 arc initiation and conduct of TIG welding Lift

To ignite the arc dwutaktu mode, press the button in the handle grip to turn the gas flow. touch electrode material welded short rub and tear. After
the correct initiation of arc welding lead the button pressed. Releasing the button on the handle causes the start of the current phase of descent and
ending the welding process.
To ignite the arc czterotaktu mode, press the button in the handle grip to turn the gas flow. touch electrode material welded short rub and tear. After
the correct arc is lit button can be released and welding lead to the slow button. To complete the welding press again and release the button on the
handle.

10.2.3 TIG welding in 2T :

10.2.3 TIG welding in 2T :
• 0 : 0 : Press and hold the handle. Starts the flow of protective gas;
• 0 ~ t1 : Pre-gas; 0 ~ t1 : Pre-gas; 0 ~ t1 : Pre-gas; 0 ~ t1 : Pre-gas; 0 ~ t1 : Pre-gas;
• t1 ~ t2 : The arc, the welding current increases from the minimum value to the set value t1 ~ t2 : The arc, the welding current increases from the minimum value to the set value t1 ~ t2 : The arc, the welding current increases from the minimum value to the set value t1 ~ t2 : The arc, the welding current increases from the minimum value to the set value t1 ~ t2 : The arc, the welding current increases from the minimum value to the set value
welding current. If the pulsator is activated, the current is modulated.
• t2 ~ t3 : During the welding of the handle should remain depressed; t2 ~ t3 : During the welding of the handle should remain depressed; t2 ~ t3 : During the welding of the handle should remain depressed; t2 ~ t3 : During the welding of the handle should remain depressed; t2 ~ t3 : During the welding of the handle should remain depressed;
Note: If you turn on the pulsator, welding current flashes, if the pulsator is off, the welding current is constant
t3 : t3 : Release the holder, welding current begins to fall. If you turn on the pulsator, falling current is modulated;
• t3 ~ t4 : The welding current drops to a minimum value, the arc is extinguished; t3 ~ t4 : The welding current drops to a minimum value, the arc is extinguished; t3 ~ t4 : The welding current drops to a minimum value, the arc is extinguished; t3 ~ t4 : The welding current drops to a minimum value, the arc is extinguished; t3 ~ t4 : The welding current drops to a minimum value, the arc is extinguished;
• t4 ~ t5 : Post-gas. t4 ~ t5 : Post-gas. t4 ~ t5 : Post-gas. t4 ~ t5 : Post-gas. t4 ~ t5 : Post-gas.
• t5 : t5 : The solenoid valve closes the gas flow, the completion of welding.
13