Table of Contents
Advertisement
Important Safety Instructions
This manual contains important instructions that should
be closely followed during installation and maintenance of
this unit. Read all safety and operating instructions before
attempting to operate the MicroDC. Adhere to all warnings
on the unit and in this manual. Follow all operating and user
instructions.
This product is designed for commercial / industrial use
only. This product is not intended for use with life support or
mediacal equipment.
Operate this product in an indoor environment at an ambient
temperature of 00°C to 55°C with a relative humidity of 20%
to 85% (non condensing). Install the product in a clean
environment, free from dust, moisture, flammable liquids,
gases, and corrosive substances.
Where applicable, this product must be permanently connected
and powered from a suitable single-phase AC supply rated in
accordance with the equipment data plate. It must be suitably
grounded and protected by a circuit breaker or fuse. A residual
current device (commonly known as differential relay) must
be present in order to protect any engineer while installing,
maintaining or operating the MicroDC.
Ensure the MicroDC has proper ventilation. Never block or
insert objects into the ventilation holes or other openings.
Maintain a minimum clearance of 500mm /19.7 inches in front,
rear and top of the MicroDC for proper air flow and cooling.
www.signamax.com
Micro Data Center Technical Manual 3
Advertisement
Table of Contents
