Program Setting Times And Display Information - Sunbeam Quantum SmartBake BM7800 Instruction/Recipe Booklet

Program Setting Times and Display Information.

The LCD window will tell you if there is a problem
with your Quantum SmartBake. Always use your
Quantum SmartBake in a room free of drafts. Do
DISPLAY READS
"0:00" (:) flashing
"E:01" flashing
"E:02" flashing
"E:03" flashing
"E:04" flashing
"E:05" flashing
"E:08" flashing
Note: After baking a loaf of bread, it is recommended to cool the breadmaker down to room
temperature as temperatures above ambient reduce the rising height of the bread due to the
sensitivity of yeast.
You will hear a beep when:
The power is turned ON
Select a setting from the Menu
Invalid key-in
Commencement of baking cycle
Completion of bread baking process
not use your Quantum SmartBake outdoors, near a
heat vent or in direct sunlight.
PROBLEM
Select program setting.
The baking chamber is too
hot to begin another cycle.
Sensor malfunction.
Sensor malfunction.
CPU malfunction
Heater control malfunction.
Heater control malfunction.
Long beep
Short beep
Long beep
2 long beeps
Short and Long beeps
76
SOLUTION
Use the Menu button to
select program.
Open the lid and remove
bread pan to cool the chamber.
After the panel message
disappears, put the bread pan
back into the chamber and
press START again.
Contact Customer Service
on the toll free number
1800 025 059.