Line; Setting Up The Auto Iris - Sony HDC-750A Operation Manual

2
Rotate the MENU SEL control to display the
AUDIO page, and push the MENU SEL control.
INPUT MODE: Change the audio input mode for
channels 1 and 2.
CCU audio lines
INPUT MODE
Channel 1
1 Rear microphone
input
2 Line rear input
3 Front microphone Rear microphone
input
4 Front microphone Rear line input
input
5 None
CH1 GAIN: Used to set the gain value for
microphone 1 (–60, –50, –40, –30, or –20 dB).
CH2 GAIN: Used to set the gain value for
microphone 2 (–60, –50, –40, –30, or –20 dB).
MIC POWER: Turn phantom power supply ON
or OFF, or set to AB powering.
INCOM1/2: Selects Prod (producer line) or ENG
(engineer line) for intercom line 1 and 2.
3
Rotate the MENU SEL control to align the "n "
marker with the item to be changed, and push the
MENU SEL control.
The "n " marker will change into a "?" mark.
4
Rotate the MENU SEL control to change the
setting to the desired value, and push the MENU
SEL control.
The "?" mark will change back to the "n " marker
and the new setting will be saved.
5
To set the values for another items, repeat steps 3
and 4.
6
To end menu operations, set the VF DISP switch to
ON.
The menu display will disappear from the
viewfinder screen, and the status of items set to
ON will be displayed on the screen.

4-5-6 Setting up the Auto Iris

The AUTO IRIS page of the OPERATION menu is
used to set up items related to the auto iris.
Channel 2
Rear microphone
input
Line rear input
input
AES/EBU
standard input
1
2
3
4
5
Chapter 4 Adjustments and Settings for Recording
VF DISP switch
MENU SEL control
Set the VF DISP switch to MENU.
The OPERATION menu will be displayed on the
viewfinder screen.
Rotate the MENU SEL control to display the
AUTO IRIS page, and push the MENU SEL
control/button.
AUTO IRIS: Set to ON to use the auto iris.
WINDOW SEL: Used to select the auto iris
window.
1 2 3
IRIS CLOSE: Used to set the iris close to ON or
OFF.
Rotate the MENU SEL control to align the "n "
marker with the item to be changed, and push the
MENU SEL control.
The "n " marker will change into a "?" mark.
Rotate the MENU SEL control to change the
setting to the desired value, and push the MENU
SEL control/button.
The "?" mark will change back to the "n " marker
and the new setting will be saved.
To set the values for another items, repeat steps 3
and 4.
4 5
(Continued)
4-15(E)