Attaching A Camera Adaptor - Sony HDC-750A Operation Manual

Hide thumbs Also See for HDC-750A:
Table of Contents

Advertisement

3-2 Connections
3-1 Precautions

3-2-1 Attaching a Camera Adaptor

Attaching an HDCA-750A HD Camera Adaptor
makes it possible to connect a VTR, Camera Control
1
Mount the camera adaptor on the rear of the
camera.
Hook the adaptor on the top part of the CA mount
of the camera, then press the lower parts of the
adaptor and camera together until you hear a click
telling you that the matching connectors have been
engaged with each other.
Make sure the camera adaptor stays firmly in place
even if you try to move it.
2
Tighten the camera's CA screw.
To remove the camera adaptor
Turn the camera's CA screw counterclockwise to
loosen it, and push the screw inwards to remove the
adaptor.
Turn the CA screw counterclockwise
until loose, then push inwards.
3-2(E)
Chapter 3 Preparations
Unit, or an HDCD-50 HD Signal Distributor to this
camera.
Tighten the CA screw.
Connecting a VTR to the camera adaptor
You can connect a VTR to the camera adaptor attached
to the camera, as shown in the figure below.
HDCA-750A HD Camera Adaptor
HDC-750A
26-pin
HDCZ-25 (25 meter (82 ft))
HDCZ-10 (10 meter (33 ft))
26-pin Connection Cable
Portable HD VTR

Advertisement

Table of Contents
loading

Table of Contents