Lubrication; Lubricating The Machine; Engine Maintenance; Servicing The Air Cleaner - Toro CM-658H-S Operator's Manual

Lubrication

Lubricating the Machine

Service Interval: Monthly—Grease the trunnions and
the drum spindle.
Grease Type: No. 2 lithium grease.
1. Complete the procedures listed in
Machine for Maintenance (page
2. Clean around each grease fitting with a rag and
lift the plastic cap off the grease fitting
41).
3. Use a grease gun to lubricate the grease fittings
of both trunnions and the drum spindle with No.
2 lithium grease
4. Wipe up any excess grease.
Figure 41
Important:
Do not lubricate the pinion gear and
ring gear. Lubrication causes them to collect
abrasive materials and accelerate wear.
Preparing the
29).
(Figure
(Figure 41).

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Before each use or daily—Inspect
Every 50 hours—Clean the air-cleaner
elements. Clean them more frequently in dusty
operating conditions.
Every 300 hours/Yearly (whichever comes
first)—Replace the paper air-cleaner element.
Replace it more frequently in dusty operating
conditions.
Important:
Do not operate the engine without
the air-filter assembly; extreme engine damage
will occur.
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page
3. Remove the nut that secures the cover
42).
g019678
31
the air-cleaner elements.
30).
(Figure