To Apply Power - Sun Microsystems SG-XPCIE1FC-EM8-Z Installation Manual

FIGURE 2-4
2. Connect the other end of the cable to the FC device.
After the optical cable is connected to the HBA, you can power on the system.

▼ To Apply Power

1. Verify that the HBA is securely installed in the system.
2. Verify that the correct fiber-optic cable is attached.
3. Refer to your system installation or service manual to determine how to power
on the system.
▼ (LED) Status
Yellow and green LEDs can be seen through openings in the mounting bracket of
the HBA. Each port has a corresponding set of yellow and green LEDs (see
FIGURE 2-5
14 Sun StorageTek 8 Gb FC PCI-Express HBA, Emulex Installation Guide • December 2008
Attaching the Optical Cable
).