POWER UNIT LOCATION IMPORTANT The D-12A Alignment Lift MUST be installed in the configuration shown in Figure 1. For the D-12 ONLY, the power unit can be located at either "X" locations shown in Figure 1 or 2. It is important to locate the POWERSIDE runway (with cylinder) on the SAME SIDE as the power unit location.
Fig 19 Fig 22 Mount the power unit to the mounting bracket using the hex bolts and nylon nuts. Fill reservoir with AW32 HYDRAULIC OIL or DEXRON III or VI ATF (See Fig 20-21) Fig 20 (See Fig 23-24) Fig 23 Fig 24 Fig 21 W32 hydraulic oil or Dexron III or VI automatic...
(See Fig 32) Fig 32 Make sure the power unit reservoir is full with 12qts of AW32 hydraulic oil or Dexron III or VI automatic transmission fluid. Filler Cap FILL WITH AW32 HYDRAULIC OIL OR DEXRON III OR VI ATF...
The purchaser of any DANNMAR product (Buyer) assum es the risk of verifying all m aterials or resources used or relied on. In no event will DANNMAR be liable to the Buyer or to anyone else for any decision m ade or action taken in reliance on inform ation obtained from any DANNMAR website or from any DANNMAR dealer, or third-party website, or any online or published catalog.
Page 37
Agreem ent, including statem ents m ade by sales persons. No em ployee of DANNMAR or any other party is authorized to m ake any warranty in addition to those m ade in the Agreem ent.
DANNMAR has made any attempt to service or modify the tool prior to its return to DANNMAR under this Warranty. In no event will either party be liable for any damage caused by the other party’s failure to fulfill its responsibilities, under these terms and conditions.
Page 39
T HI S P A GE I S I NT E NT I O NA L L Y L E F T B L A NK .