Table of Contents
Advertisement
the correct height. Retighten lock nuts after adjustment is complete.
a. To adjust the conveyor up into the drive gear, turn the conveyor adjustment screw
clockwise. Use a 7/16-end wrench to tighten the jam nut.
b. To adjust the conveyor away from the drive gear, turn the conveyor adjustment screw
counterclockwise. Use a 7/16-end wrench to tighten the lock nut.
5.
Replace front panel.
6.
Feeder Assembly
Install Feeder by fitting slots on back of feeder
onto back panel studs located at top rear of
unit.
7.
Install Teflon Sheet (Optional)
Remove Feeder. Allow one end of the Teflon
sheet to overlap the top of the rear panel to
the rear studs. Align the holes in the sheet
with the stud heads and push the sheet over
the stud heads. Balance of the sheet will fit
over
the
grill
c a p t u r i n g
the feeder and the top of the toaster.
Place the toaster on a flat surface. This toaster is tested and approved for zero clearances against
heated
surfaces. Locate the toaster near a wall receptacle of the proper configuration.
EXTENSION CORD.
label. Outlets must be properly grounded.
Choose Dry or Wet operation.
1.
Dry operation.
a. Turn Main Power Switch on. Set Temperature Control knob to desired temperature. Allow Pilot
Light to cycle at least two times (on/off). When the light is on, the grill is heating. Heat up time is
about 15-20 minutes.
b. Turn on motor switch. Conveyor should start to turn.
c.
Place bun halves on feeder cut side down (facing grill surface). Toast time is approximately 210
sec. depending on bun height and diameter. Increase or decrease temperature setting to
achieve desired brownness and temperature.
2.
Wet operation.
toasting using oil, any high-quality cooking oil may be used with this toaster (do not use oils that
contain dairy products such as butter). The Teflon sheet may be used, but it is not required.
a. Turn Main Power Switch on. Set Temperature Control knob to desired temperature. Allow Pilot
Light to cycle at least two times (on/off). When the light is on, the grill is heating. Heat up time is
about 15-20 minutes.
b. Turn on motor switch. Conveyor should start to turn.
c.
Hold bun half in the palm of the hand, place butter on cut side..
d. Place bun halves on feeder cut side down (facing grill surface). Try several buns to determine
the correct pressure and time to achieve the desired browning and temperature of bun. Using
too little oil will cause the bun surface to be cool and uneven in color. It will also cause the bun to
stick to the grill. Using too much oil will give the bun a yellow un-toasted look. Toast time is
approximately 210 sec. depending on bun height and diameter. Increase or decrease the
surface.
Reinstall
Te f l o n
S h e e t
b e t w e e n
Plug the power cord into an outlet (receptacle) of the specified voltage on the rating
OPERATING INSTRUCTIONS
(no oil) Insure Teflon sheet,
(using oil) Apply a light coating of oil to grill surface. (Fry oil can be used) When
Feeder
LOCATION
86298
is properly installed.
4
FIGURE 2
Jam Nut
Screw
DO NOT USE AN
non-
Advertisement
Table of Contents
