Getting Started; Unpacking The Device - T-COM Speedport OptoLAN Manual

Speedport OptoLAN / T-Com_en / A31008-M1062-A151-2-7419 / starting.fm / 12.09.2006

Getting started

Your Speedport OptoLAN is a high quality device that will only operate
to your full satisfaction if you comply with all the requirements for star-
tup.
Put your Speedport OptoLAN into service as follows:
■
■
■
■
■

Unpacking the device

Package contents
■
■
■
■
■
■
Checking the package contents
Before you put your Speedport OptoLAN into service, you should
check it carefully to make sure it is not damaged.
■
■
Never put the device into operation if it is damaged! If you have any
doubts, you should contact T-Com Customer Service (see page 11).
Note
Unpack and check the package contents
Set the device up
Connect the POF cable
Connect the Ethernet cable
Connect the device to the power supply
Two Speedport OptoLANs
Two plug-in power supplies for Speedport OptoLAN
30 m POF cable
One POF cable cutter
Two Ethernet cables (cat. 5, gray, 1.80 m)
Printed user guide
Is there any visible damage to the packaging, indicating that the
device could have been dropped during transport?
Is there any visible damage to the casing or the plug-in power sup-
ply or the network cable?
Keep the original device packaging. You can use it to
transport the device during a move or to dispatch it else-
where.
Getting started 5