Installation Instructions; Ubg-16 Over View; Troubleshooting Suggestions - Electronics International UBG-16 Installation Instructions Manual

"UBG-16" "UBG-16"
1. 1. 1. 1. 1. "UBG-16" "UBG-16" "UBG-16" Over View
The UBG-16 was designed for use in a single engine aircraft. (For twin engines, use two UBG-
16's.)
On the back of the UBG-16 are three circular connectors. As seen in
the diagram to the right:
The first 1 to 7 channels of the LEFT 16-pin connector are used to
monitor EGT's. Any remaining channels may be used to monitor
other functions.
The first 1 to 7 channels of the RIGHT 16-pin connector are used
to monitor CHT's. Any remaining channels may be used to
monitor other functions.
The small 9-pin connector connects the instrument to power,
ground, display intensity control, RS232 Recorder and any warn-
ing devices.
The UBG-16 comes with three preassembled wire harnesses which simply plug into the three
circular connectors at the back of the instrument. Two of the wire harnesses are identical. One
will be used to connect the EGT probes to the UBG-16 and the other will be use to connect the
CHT probes to the UBG-16. The wire harnesses were assembled with only enough cables to
accommodate the EGT and CHT channels. Any additional temperature measurement (TIT, OAT,
Carb Temp, Cowl, etc.) requires a Type K thermocouple extension cable be added to the appropri-
ate harness. Any desired function such as RPM, M.P., Oil Pressure, Fuel Pressure, Fuel Flow,
Gyro Vacuum, Volts, Amps, etc., requires an Electronics International Functional Module be
added to the appropriate harness.
The UBG-16 does not require any programming before installation. All setup can be accomplished
on the face of the instrument. The UBG-16 does not use any internal batteries, so once installed
the instrument never has to be removed from the panel.
Read step #2 below then perform only the remaining steps that apply to your configu- Read step #2 below then perform only the remaining steps that apply to your configu-
Read step #2 below then perform only the remaining steps that apply to your configu- Read step #2 below then perform only the remaining steps that apply to your configu- Read step #2 below then perform only the remaining steps that apply to your configu-
r a t i o n . r a t i o n . r a t i o n . r a t i o n . r a t i o n .
INST INSTALLA INST ALLA ALLATION INSTR ALLA TION INSTR TION INSTRUCTIONS TION INSTR
INST INST ALLA TION INSTR
Over View Over View Over View Over View
UBG-16 UBG-16 UBG-16
UBG-16 UBG-16
UCTIONS UCTIONS UCTIONS
UCTIONS
3
16-Pin 9-Pin 16-Pin
EGT's CHT's