Electronics International UBG-16 Installation Instructions Manual page 22

Adding a Temperature Probe to the UBG-16
If you have an unused channel and would like to add an extension cable and probe to your instrument, perform
the following steps:
1. Order an XCS Extension Cable (at the proper length) and appropriate probe from Electronics
International Inc.
2. Disconnect the cable harness at the Circular Connector on the back of the UBG.
3. Insert the the XCS Extension Cable into the Circular Connector at the proper location (see below).
Once these connectors are installed do not try to remove them without an extraction tool. Unless an
extraction tool is used you can damage the Circular Connector. An extraction tool may be pur-
chased from Electronics International Inc.
4. Follow the appropriate steps in the Installation Instructions for mounting the probes and routing the
Extension Cables.
5. Reconnect the cable harness to the Circular Connector at the back of the UBG.
Appendix A
Extension Cable Harness
Back View (wire side)
2
1
Yel
3 2
3
6
Red Yel
Yel
5
10 5
Red
Yel
7 6
7
Yel Yel
Red
14
8
16
Yel
18
Note: 1 Red = Channel #1 Red wire.
1 Yel = Channel #1 Yel wire.
1
1
Red
3
2
Red
4
4
7
Red
Yel
6
11
Red
8
15
Red