Electronics International UBG-16 Installation Instructions Manual page 3

P-110 Standard EGT Probe
Impor Impor tant Installation Inf tant Installation Inf
Impor Impor tant Installation Inf Impor tant Installation Inf tant Installation Inf ormation
All steps All steps All steps All steps All steps must must must must be read before installing a probe. must
2. Do Not Overtighten.
Over time, tight wire wraps
will cause the wire to break.
3. Both clip rings must be on the
inside of the hose clamp.
The rubber band is used to hold
the washer on during shipping.
4. The Type-K thermocouple wire's yellow and red insulation must
be stripped 3/8" for proper overlap in the OLC-1 (Over-Lap Con-
nector). Back out the set screw, insert wires into opposite ends
(matching colors) so wire insulation is just inside the nylon housing
and the ends of the wires are not exposed on the opposite side.
Tighten the set screw until the set screw stops turning and the hex
driver starts to flex (4-5 in-lbs). Tug on the wires (1-2 lbs) to
insure proper connection.
be read before installing a probe. be read before installing a probe. be read before installing a probe. be read before installing a probe.
1. Leave slack in the cable to allow
for engine movement and vibration.
ormation ormation
ormation ormation
S.S. Washer.
Hose Clamp.
Drill 13/64" Hole
(See II Manual)
1218121