Electronics International UBG-16 Installation Instructions Manual page 4

P-110 Fast Response EGT Probe
Impor tant Installation Inf Impor Impor tant Installation Inf tant Installation Inf ormation tant Installation Inf
Impor Impor tant Installation Inf
All steps All steps must must
All steps All steps must All steps must must be read before installing a probe.
2. Do Not Overtighten.
Over time, tight wire wraps
will cause the wire to break.
3. The slit in the ferrule must be
placed perpendicular to the hose
clamp band and the spring must
be 3/8" back from the ferrule. If
the probe is placed in a hole
larger than 0.130", use a S.S.
washer between the exhaust pipe
and the ferrule.
4. The Type-K thermocouple wire's yellow and red insulation must
be stripped 3/8" for proper overlap in the OLC-1 (Over-Lap Con-
nector). Back out the set screw, insert wires into opposite ends
(matching colors) so wire insulation is just inside the nylon housing
and the ends of the wires are not exposed on the opposite side.
Tighten the set screw until the set screw stops turning and the hex
driver starts to flex (4-5 in-lbs). Tug on the wires (1-2 lbs) to
insure proper connection.
be read before installing a probe. be read before installing a probe.
be read before installing a probe. be read before installing a probe.
1. Leave slack in the cable to allow
for engine movement and vibration.
ormation ormation ormation
ormation
3/8"
Drill 0.130" Hole
(See II Manual)
1218122
Hose Clamp.