Draining & Decommission - Lavit LB115 Series Troubleshooting Manual

Draining & Decommissioning The Lavit Cooler
1. Turn off the water supply to the m a c h i n e.
2. Using a suitably sized bucket drain the main water tank 1
3. Remove the rear bung and drain water to the bucket until the flow stops, tip cooler
Back to ensure all water is drained.
4. If the "error" screen appears then reset it by powering the machine off
5. Drain the soda water only after the main tank has been drained. This is done by
accessing the soda purge program in the service
6. Drain the soda until it blows CO2 gas o n l y .
7. Turn off the power.
8. Turn off the CO2 and remove the CO2 bottle.
9. Secure the CO2 regulator.
10. Purge CO2 gas from the purge valve on the rear of the
11. Replace the still water drain bung and secure with the # 2 Stainless Steel Screw.
12. Remove the power cord
13. Secure the drip tray, power cord, and CO2 regulator in the polystyrene with the
dispenser.
14. Pack the machine in a protective bag and or original packing.
15. Failure to protect the machine during transport can lead to panel damage
NOTE:
➢ ALWAYS! Transport the machine in an upright p o s i t i o n .
st
. (1.5 gallon)
screen.
machine.
37
and on.