Table of Contents
Advertisement
Pic # 1
Replacing the Soda Probe
Step -1 Open the beverage lid remove the 4-
screws shown below. Then lifting upwards in
the center rear section of the top cover,
unsnap and remove top cover
14
Step -2 Remove all Screws
shown in diagram below.
Then Look Over top edge of
panel to locate the internal
side panels crew Using Long #
2 Phillips bit remove screw
before removing side cover.
See Pic # 1
Release plastic snap
before removing side
cover
18-11-26-REV-A
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
