Carson MicroFlip MP-250 Instructions For Use Manual
100x–250x zoom pocket microscope
Hide thumbs
Also See for MicroFlip MP-250:
- Manual (13 pages) ,
- Quick start manual (3 pages) ,
- Instructions for use (3 pages)
Related Manuals for Carson MicroFlip MP-250
Summary of Contents for Carson MicroFlip MP-250
- Page 1 MP-250 MicroFlip 100x–250x Zoom Pocket Microscope Instructions for Use PDF: www.carson.com/MP250guide English / Français / Español / Deutsch /日本語...
-
Page 2: Table Of Contents
Adjusting Zoom & Focus ......6 UV light switch UV Light ............6 Using the Adapter Clip ......7 Zooming dial Multiple-Lens Camera Phone....8 Battery door Storage/Safety Information ....8 Customer Service ........8 Base plate Objective lens Carson Optical UV light 2070 5th Avenue Ronkonkoma, NY 11779... -
Page 3: Installing The Battery
Left Side Installing the battery Adapter clip Fig.1 Slide open the battery door. Eyepiece LED switch Fig.2 Install 1 (one) AA alkaline battery with the correct polarity. Focusing ring Fig.3 Attach the battery door. -
Page 4: Objects Directly
Using the microscope to view: OBJECTS DIRECTLY Fig.4 Fig.5 Fig.6 Press the LED switch to turn on the LED. Make sure the base plate sits behind the Place the viewing object directly below battery door in the upright position. the objective lens. WARNING Do not look directly at LED light. -
Page 5: Specimen Slides
Using the microscope to view: SPECIMEN SLIDES Fig.7 Fig.8 Fig.9 Press the LED switch to turn on the LED. Flip the base plate down so that it sits on Insert the specimen slide (included) into the base of the microscope. the slot between the objective lens and the base plate. -
Page 6: Adjusting Zoom & Focus
Adjusting zoom & focus UV light Fig.10 Fig.11 Fig.12 Adjust the zooming dial to the desired Rotate the focusing ring until the image is Press and hold the UV light switch to level of magnification. sharp and clear. activate the UV light. NOTE: The UV light is deactivated when the base plate is flipped down to the base of the microscope. -
Page 7: Using The Adapter Clip
Using the adapter clip Fig.13 Fig.14 Fig.15 Attach the adapter clip to the top of the microscope as shown in Fig. 14 and turn on camera. Refer to pages 4-5 for procedures of using the microscope. If viewing image is not centered or is not a complete round image, adjust adapter clip making sure it is... -
Page 8: Multiple-Lens Camera Phone
For Android, the primary camera can be determined by which does not show an image in your app while blocking the individual camera. For the latest instructions on multiple camera phones, please visit www.carson.com/multicam. Storage/Safety Information: • Turn off the LED at the end of the observation by pressing the LED switch.
Need help?
Do you have a question about the MicroFlip MP-250 and is the answer not in the manual?
Questions and answers
Just got 250 from Amazon. Can't see anything through objective lens. And yes, I did put in a battery.
If you cannot see anything through the objective lens of your Carson MicroFlip MP-250, ensure the following:
1. Confirm the battery is installed correctly and the LED light is turned on.
2. Make sure the base plate is in the correct position:
- Upright for viewing objects directly (uses front-facing LED).
- Downward for viewing specimen slides (uses downward-facing LED).
3. Position the object or slide directly under the objective lens.
4. Adjust the zooming dial and focusing ring to bring the image into focus.
If the issue persists, inspect the battery for corrosion or leakage and replace it with a new alkaline AA battery.
This answer is automatically generated