Technical Data - Worx WG157E Manual

1. AUXILIARY HANDLE
2. LOCK OFF BUTTON
3. ON/OFF SWITCH
4. BATTERY PACK*
5. SAFETY GUARD
6. FLOWER GUARD
7. LINE CUTTER
8. TRIMMER HEAD COVER (See Fig.J)
9. CAP RELEASE LATCH (See Fig.J)
10. SPOOL (See Fig. J)
11. TRIMMER HEAD (See Fig. J)
12. EYELET (See Fig. J)
13. LINE FEED BUTTON (See Fig. H)
* Not all the accessories illustrated or described are
included in standard delivery.
8

TECHNICAL DATA

Type WG157E WG157E.9 (1-designation of
machinery, representative of Cordless Grass
Trimmer)
Voltage
No load speed
Cutting diameter
Line diameter
Charging time
Machine weight
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
2-in-1 Grass Trimmer/Edger
WG157E WG157E.9
20V Max** Lithium
8500/min
25cm
1.65mm
/
Approx. 3hr
1.9kg 1.5kg
NOISE DATA
A weighted sound pressure L
A weighted sound power L
K
pA
Wear ear protection.
VIBRATION INFORMATION
Typical weighted vibration
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING! The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Avoid using tools in temperatures of 10ºC or less.
Plan your work schedule to spread any high
vibration tool use across a number of days.
80dB(A)
pA
94dB(A)
wA
3.0dB(A)
a < 2.5m/s²
h
Uncertainty K=1.5m/s²
EN