Table of Contents
Advertisement
Hardware installation
1. Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist strap terminal.
2. Remove the caps from the cage sockets on the FIM-7920E front panel.
3. Hold the sides of the transceiver and slide it into the cage socket until it clicks into place.
Installing the optional front cable management bracket
Your FIM-7920E package includes a front cable management bracket. This bracket helps support the relatively large
QSFP28 transceivers used to connect the front panel C1 to C4 interfaces to your networks.
Using the front cable management bracket is optional, but if you decide to use the bracket it should be attached to the
FortiGate-7000 chassis left and right cable management brackets.
Install one front cable management bracket for each FIM-7920E after you have installed the FIM-7920E in your
FortiGate-7000 chassis.
Installing FIM-7920E front cable management brackets in a FortiGate-7040E chassis
M4x8 flat-head
screws
M4x8 large head
pan head screws
Left cable
management
bracket
Optional front
cable management
brackets
FIM-7920E Processing Module Guide
Front mounting
bracket
Right cable
management
bracket
Front mounting
bracket
M4x8 large head
pan head screws
Power cord
M4x8 flat-head
screws
Fortinet Technologies Inc.
13
clamp
Advertisement
Table of Contents
