Daikin LMS Series Installation & Operation Manual page 20

Straddle version:
Before mounting the unit prepare the cuts in the cold room wall as shown in the picture.
Fix the unit in place with the appropriate screws. Position the unit on the cold room, connect the evaporator
drain tray spigot and the hole prepared in the cold room wall using the supplied pipe with pre-inserted
heater (for low temperature units only). Fill the hole in the wall with insulating material, polyurethane or
silicone, and mount the hole cover.
LMSMD030-050-060-075-100/LMSLN100-120-170
LMSMD102-120-122-130 / LMSLN172-200
LMSMD150-200 / LMSLN300
Thru-wall version (optional):
A) Prepare a opening with suitable dimensions in the cold room wall (see picture).
B) Position the unit onto the cold room wall inserting the evaporator section in the opening.
C) Fix the unit using the screws supplied.
ATTENTION
Check that the unit and its devices have suffered no damages during transport. Pay
special attention to the components
secured to the electric panel door and to the refrigerating circuit pipes. Mount the unit
as shown in the drawings; make sure that the electric connections are carried out
properly.
20
Max 120
Mod.
Inject silicone all around
the panel opening
Max 120
LMSMD030-050-060-075-100/LMSLN100-120-170
LMSMD102-120-122-130 / LMSLN172-200
B C
324 295
324 595
400 542
Mod.
LMSMD150-200 / LMSLN300
D E F
80 55 147,5
80 55 297,5
65 85 271
Hole
H
H
425
725
725
G
147,5
297,5
271
I
I
335
335
475