Sub-Zero 650G Manual page 10

Planning Information
Built-In Model 650G
O V E R L A Y P A N E L S
Overlay Panel
1 /4
"(6) Backer Panel
Spacer Panel
3"
(76)
1 /2
"
Bottom Edge –
(13)
Hinge Side
(rear view)
3 /8
"
(10)
Recessed area for hinge plate
Overlay Panel
Spacer Panel
Backer
Panel
5 /16
(8)
27 /32 "
17 /32
(21) "
(13)
Reveal area for door panel
Dimensions in parentheses are in
millimeters unless otherwise specified.
O V E R L A Y P A N E L S
IMPORTANT NOTE: For overlay door panels, it is neces-
sary to rout a space for the unit's lower hinge plate so
that it does not strike the door panel. Refer to the top
illustration on this page.
You will minimize the reveal between the bottom of the
overlay door panel and the top of the overlay drawer panel.
Refer to the bottom illustration on this page.
If you choose not to rout a space for the lower hinge plate,
you can reduce the total height of the overlay panel (deco-
rative panel only) by
Do not exceed the overlay panel dimensions listed. If
you try to make the reveal tighter between the door
and drawer panels, the panels may hit when opening
and closing, causing possible damage to the panels and
the Sub-Zero unit.
"
1
/ " (13).
2
10