HEIDENHAIN ND 780 Installation Instruction page 12

ND 780
Installation Instructions
Wiring the power connector
The ND 780 includes a power connector that needs to be wired to a suitable power cord;
see Power cord on the previous page.
To wire the power connect:
Verify that the power cord is not plugged into the main power supply.
Wire the power connector according to the diagram on the right.
Connecting a power cord
To connect a power cord:
Verify that the power switch is in the off position.
Verify that the power cord is not plugged into the main power supply.
Insert the female end of the power cord into the power connector on the rear of the
product.
Data interface connections
Notice
This product contains components that can be damaged by electrostatic
discharge (ESD). Observe precautions for handling ESD sensitive devices and
never touch connector pins unless properly grounded.
Connecting an encoder
This product can be used with HEIDENHAIN linear, and rotary encoders that provide
sinusoidal output (11 μA or 1 V
PP
30 meters in length.
To connect an encoder:
Verify that the power switch is in the off position.
Connect the axis encoder tightly to it's connector. An input designator is provided near
each connector located on the rear of the product.
Connecting an RS-232-C cable
The RS-232-C port is used for bi-directional communication with a computer. A cross-over
cable must be used. Refer to the ND 780 Operating Instructions for more information
on RS-232-C communications.
To connect an RS-232-C cable:
Verify that the power switch is in the off position.
Connect a computer's RS-232-C port to the ND 780 RS-232-C port (X31) located on the
rear of the product. Use the HEIDENHAIN cable ID 366964-xx.
12
) signals. The connecting cable must not exceed
PP
Observe ESD handling precautions
6
X1, X2, X3 - 11 μA /1 V
PP PP
7
X31 - - RS-232-C