Install Amplifier And Supplementary Wiring Harness - BMW Retrofit kit Sound Module System II Installation Instructions Manual

7 . Install amplifier and supplementary wiring harness (mounting system at I
beam, only vehicles without on-board monitor radio with battery in the boot)
40
40
41
43
Retrofit/Installation Kit no. 82 83 0 022 122
Installation Instructions no. 01 29 0 022 772
2
7
1
2
F 46 0736 B
40
F 46 0737 B
5
F 46 0738 B
4
40
41
42
F 46 0722 B
Date: 04.2000
Place amplifier bracket for fitting against the I
beam (7) on the amplifier (1) and screw it on with
four fillister head self-tapping screws 3.5x9.5 (2).
Take note of the position of the opening (40)
for the connector of the adapter cable.
Illustration shows driver's footwell:
Cut insulating mat above mounting screw (40) of
the control unit box in the engine compartment
on the left and screw out mounting screw (40).
Screw amplifier bracket for fitting against the
bulkhead (5) using existing mounting screw (40)
of the control unit box into the existing drill hole
(41) in the bulkhead.
Plug together the black 17-pole radio
connector (40) with the black 17-pole pin
housing (41) of the adapter cable (4).
If necessary, move the position of the plug of
the connection cable for the CD changer in the
black 17-pole socket housing (42) of the adapter
cable (4).
Connect the black 17-pole socket housing (42) of
the adapter cable (4) to the radio.Then install the
adapter cable (4) with the black 25-pole
connector (43) to the installation location of the
amplifier and fasten it with cable straps.
EN/48