Installation - Ecolink H114101 Installation Instructions Manual


Controller inclusion mode must be activated BEFORE starting sensor inclusion mode.

The sensor can only be included into one controller network at a time, and must be excluded from one network before inclusion in another.

Removing the pull tab connects the battery and initiates sensor inclusion mode. Inclusion mode can also be initiated by removing the battery for at least 5 seconds,
reinstalling the battery, then replacing the sensor cover.

The plastic pull tab must be removed to enable sensor operation.

The sensor automatically enters inclusion mode at power-up.

Exclusion mode on the senor is initiated following the same exact procedure as inclusion.

Installation

The package contains the following:
1- Door/Window Sensor
1- Sensor Mounting Bracket
2- Screws for Sensor Mounting Bracket
1- Adhesive tape for Sensor Mounting Bracket
1- Sensor Magnet
2- Screws for Sensor Magnet
1- Adhesive tape for Sensor Magnet
Identify Location for Sensor and Magnet:
STEP ONE
Determine where on the door or window you are able to mount the sensor and magnet. Note, that the sensor has a line and arrow that identify where the magnet
should be located, relative to the sensor.
The sensor is typically attached to the non-moving part of the door or window (i.e. the door jamb or window frame). For your convenience two mounting methods
are provided. The sensor can be mounted with adhesive tape and/or screws.
First make sure you have a flat clean surface to mount the sensor and magnet to. Please verify the correct orientation of the sensor and location of the magnet
before you continue on to mounting the sensor and magnet.
Magnet Location
© 2018 Ecolink Intelligent Technology Inc. PN H114101