Canopy Replacement - Carefree FREESTYLE EVOLUTION Service Manual

F E
REESTYLE VOLUTION
C R
ANOPY EPLACEMENT
This procedure requires two people.
1. Open the awning 18"-24".
2. Disconnect power to the awning.
3. Carefully push the lead rail toward the case so that the arms collapse and
the fabric is slack.
4. Hold the lead rail in this position and firmly tie the elbows of the spring arms
together. Use a minimum 1/2" rope - do not use bungee cords. When tying
the rope, use a non-slip knot such as a square knot or equivalent.
CAUTION
will allow the spring arms to unexpectedly extend out possibly causing personal injury and
damage to the awning.
NOTE: The illustrations show the RH motor configuration. Instructions are the same for LH motor configurations.
5. On the motor side:
5.1. Remove the fabric retaining screw from the
lead rail endplate.
5.2. Remove the outer end cap and set aside.
5.3. Disconnect the motor quick connects.
5.4. Remove the two (2) motor screws and two
(2) cover screws from the end plate.
6. On the idler side:
6.1. Remove the lead rail endplate and set
aside.
6.2. Remove the outer end cap and set aside.
6.3. Remove the five (5) screws and case
endplate. Set parts aside.
7. Rotate the top cover back and out of the way.
Canopy Staking for RAGM
Fabric Slot
Fabric
Retaining Screw
8. Lift the roller tube, fabric and motor up and out of the case.
9. Remove the fabric retaining screws from the motor bearing and idler end plug.
10. Pull the roller tube out of the case while pulling the fabric from the lead rail.
6
Service Manual
Failure to secure the lead rail as described
Cover Screws (x2)
Disconnect
Motor Wires
Fabric Retaining
Screw
Cover
Case Endplate
Endcap
Carefree of Colorado
Spring Arms
Firmly Tie Elbows Together
FRM007
Motor Screws
(x2)
Endcap
ragm008a
Leadrail
Endplate
ragm008b
Motor Spacer
Fabric Slot
Fabric
Retaining Screw
ragm008
070036-301Prelim