Configuring A Goose Subscriber With Iet600; Configuring Goose Inputs With Iet600 - ABB RELION REC615 Engineering Manual

Section 5
GOOSE
5.4.5
5.4.5.1
46
GoCB property
APP-ID
VLAN-ID
VLAN Priority
With the protection relays of this product series, only t(max) is
configurable, not t(min).
Conf.Rev. cannot be manually edited. IET600 updates it automatically
to the next multiple of 100 when the configuration changes.
The multicast MAC address is usually unique, and APP-ID must be
unique.

Configuring a GOOSE subscriber with IET600

The relay application can receive and use single binary, double binary, integer and
floating point values with attached quality information. A quality attribute is received
and processed automatically.

Configuring GOOSE inputs with IET600

1. Select the root node on the IEDs tab in the navigation pane.
2. Click the GCB Clients tab in the editor pane.
The rows of the GCB client editor show GoCBs, that is, "senders", and the
columns show the devices available as GOOSE clients, that is, "receivers". If the
client device is not on the same subnetwork as the GoCB sender, it cannot be
configured as a client.
Description
Unique HEX value application identifier for sending the GoCB
within the system. It identifies the purpose of this particular data
set. The value range is 0000...3FFF.
Used if the Ethernet switches in a station bus support VLAN. If
static VLAN identifiers are defined, it also affects the switch port
configuration. Value "000" indicates a non-configured VLAN and
switches do not filter these messages on a port basis. This is the
recommended if there is no need to split the logical network. The
VLAN identifier is a 3-character HEX value with range 000...FFF.
Recommended values are 2...1001.
Used in networks supporting VLANs. The priority is used with
network switches. The default value for GOOSE is "4" and the
value range is 0...7.
1MRS757809 C
REC615 and RER615
Engineering Guide