Table of Contents
Advertisement
At least once a year carry out the maintenance operations listed below. In the case of seasonal servicing, it is recommended to carry
out the maintenance at the end of each heating season; in the case of continuous operation the maintenance is carried out every 6
months.
WARNING: ALL OPERATIONS ON THE BURNER MUST BE CARRIED OUT WITH THE MAINS DISCONNECTED AND
THE FUEL MANAUL CUTOFF VALVES CLOSED!
ATTENTION: READ CAREFULLY THE "WARNINGS" CHAPTER AT THE BEGINNIG OF THIS MANUAL.
PERIODICAL SERVICING
Cleaning and examining the gas filter cartridge, if necessary replace it (see next paragraphs).
Removal, examination and cleaning of the combustion head (see Fig. 36)
Check of ignition electrode, cleaning, adjustment and, if necessary, replacement (see Fig. 37)
Check of detection electrode, cleaning, adjustment and, if necessary, replacement; in case of doubt, check the detection circuit fol-
lowing the diagram in Fig. 39 and Fig. 40, after turning the burner back into operation.
Cleaning and greasing of leverages and rotating parts.
ATTENTIONwhen servicing, if it was necessary to disassemble the gas train parts, remember to execute the gas proving
test, once the gas train is reassembled, according to the procedure imposed by the law in force.
Gas filter maintenance
ATTENTION: Before opening the filter, close the manual cutoff valve downstream the filter and bleed the gas; check that
inside the filter there is no pressurised gas.
To clean or remove the filter, proceed as follows:
1
remove the cap unscrewing the fixing screws (A);
2
remove the filtering cartridge (B), clean it using water and soap, blow it with compressed air(or replace it, if necessary)
3
replace the cartridge in its proper position taking care to place it inbetween the guides as not to hamper the cap replacement;
4
be sure to replace the Or ring into its place (C) and replace the cover fastening by the proper screws (A).
Inspection and replacement of the MULTIBLOC DUNGS MBC..SE filter (Threaded valves group)
Inspect the filter at least once a year.
Change the filter, if pressure value between pressure con-
nections 1 and 2 is greather than 10 mbar.
Change the filter, if pressure value between pressure con-
nections 1 and 2 is twice as high compared to the last ins-
pection.
1. Interrupt gas supply: close ball valve
2. Remove screws 1-2
3. Replace the filter insert 3
4. Screw in screws 1-2 without use force to fasten.
5. Perform leakage and funcion test.
Space requirements for fitting filter, A: from 150 to 230 mm.
CIB UNIGAS - M039177CA
PART III: MAINTENANCE
A
B
Fig. 35
36
C
Advertisement
Table of Contents
