Advertisement
Quick Links
I N S T A L L A T I O N I N S T R U C T I O N S
DELL QUICK CONNECT BRACKET
Model: MSP-G1
Specifications:
•
Accommodates Dell Ultra-Sharp displays up to
24" screen size.
BEFORE YOU BEGIN
WARNING: It is the installer's responsibility to make sure all components are properly assembled and installed using
the instructions provided. Failure to read, thoroughly understand, and follow all instructions can result in serious
personal injury, damage to equipment, or voiding of factory warranty.
•
If you have any questions about this these instructions or your specific installation, contact Chief Manufacturing
at 1-800-582-6480 or 952-894-6280.
CHIEF MANUFACTURING INC.
1-800-582-6480 952-894-6280 FAX 952-894-6918
8401 EAGLE CREEK PARKWAY, STE 700
SAVAGE, MINNESOTA 55378 USA
Dell Quick Connect Bracket
(Shown with optional display and mount)
8832-000153
2006 Chief Manufacturing
www.chiefmfg.com
03/06
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for CHIEF MSP-G1
Summary of Contents for CHIEF MSP-G1
- Page 1 Failure to read, thoroughly understand, and follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty. • If you have any questions about this these instructions or your specific installation, contact Chief Manufacturing at 1-800-582-6480 or 952-894-6280. CHIEF MANUFACTURING INC.
- Page 2 Centris bracket and cutout is on bottom. PARTS Tabs After unpacking carton, inspect and verify contents (See Figure 1). If any listed parts are missing or damaged, contact Chief Customer Service at 1-800-582-6480. Centris bracket Table 1: Parts (4 places) Item Description...
- Page 3 Installation Instructions Model: MSP-G1 NOTE: Mount arm not shown for clarity. Display locking lug (Left side shown; right side similar) Figure 3: Install Foam Pads Figure 5: Install Display to Lower Bracket Tabs 3. Tilt and lower display so that upper tabs of bracket 5.
- Page 4 Model: MSP-G1 Installation Instructions...
Need help?
Do you have a question about the MSP-G1 and is the answer not in the manual?
Questions and answers