Before Use - Bosch EXACT 2 Manual

Exact_bu1_3609929A00_t.fm Seite 5 Freitag, 24. September 2004 1:56 13
Centre Grip Screwdriver
Order number 0 602 490 ...
Tightening torque
No-load speed
Voltage
Rotational direction
Tool holder
Battery pack included
Weight (without accessories) approx.
* Quick change chuck
NiCad battery pack
Order number 2 607 335 ...
Number of cells
Battery voltage
Capacity
Weight approx.
4 OPERATING INSTRUCTIONS

Before Use

Please take note that the battery is not inserted in the
power tool when delivered.
Never store rechargeable batteries in a battery
powered tool. Rechargeable batteries last longer
and are easier to recharge when they are stored sep-
arately. Remember to fully recharge batteries that
have been stored for a longer time before use.
Charging the Battery
Charge the battery before inserting into the power tool
with a suitable charging unit. The exact description of
the charging procedure can be found in the operating
instructions of the charging unit.
The battery is equipped with a NTC temperature sen-
sor that allows charging only in the temperature range
between 0 °C (+32 °F ) and 45 °C (+113 °F). A long
service life of the battery is achieved in this manner.
With correct usage, the battery can be recharged up
to 3000 times.
A new battery or a battery that has not been used for
a longer time produces full power only after approxi-
mately five charge/discharge cycles.
You should not recharge a battery after brief usage
(e.g., 3 minutes) in order to protect it.
3 609 929 A00 • (04.09) T
EXACT 9 EXACT 9
... 435 ... 436
[Nm] 1.5–9 1.5–9
[RPM] 350
[V] 9.6
SWF* 1/4"
–
[kg] 0.8
9.6
... 373 ... 374
8
[V] 9.6
[Ah] 1.7
[kg] 0.4
Inserting the Battery
Press the right/left switch 3 to the middle position to
activate the switch-on lock and place the on/off switch
6 in the "off" position. This prevents the unintentional
switching on of the tool.
Slide the charged battery 4 from below into the handle
of the power tool. Take care that the battery is in the
correct position when sliding in and that it can be felt
to engage in the handle.
Quick Change Chuck
11
Take care when inserting a tool bit that the shaft
of the tool bit is seated firmly in the tool holder.
When the shaft of the tool bit is not inserted deeply
enough in the tool holder, the tool bit can slide out and
no longer be controlled.
Use only insertion tools with fitting end pieces
(1/4" hexagonal).
English–5
EXACT 12
... 441
1.5–12
350 400
9.6 12
1/4" 1/4"
q
–
1.2 0.9
12 12
... 375
10 10
12 12
1.7 2.4
0.7 0.7
Inserting the Tool
Pull the quick change chuck
10
9 to the front. Insert the tool
11 into the tool holder 10
and release
change chuck 9.
9
EXACT 12
... 442
1.5–12
400
12
1/4"
q
1.6
the quick