Before Use; Operating Instructions - Bosch ANGLE EXACT 6 Operating Instructions Manual

Industrial Cordless Angle Wrench
Order number 0 602 490 ...
Tightening torque
No-load speed
Voltage
Rotational direction
Tool holder
Delivered items
Battery-pack
Angled drive head
Weight (without accessories) approx.
Ni-Cd Battery Pack
Order number 2 607 335 ...
Number of cells
Battery voltage
Capacity
Weight approx.

Before Use

Please take note that the battery is not inserted in the
power tool when delivered.
Never store rechargeable batteries in a battery
powered tool. Rechargeable batteries last longer
and are easier to recharge when they are stored sep-
arately. Remember to fully recharge batteries that
have been stored for a longer time before use.
Charging the Battery
Charge the battery before inserting into the power tool
with a suitable charging unit. The exact description of
the charging procedure can be found in the operating
instructions of the charging unit.
The battery is equipped with a NTC temperature sensor
that allows charging only in the temperature range be-
tween 0 °C (+32 °F ) and 45 °C (+113 °F). A long service
life of the battery is achieved in this manner. With correct
usage, the battery can be recharged up to 3000 times.
A new battery or a battery that has not been used for
a longer time produces full power only after approxi-
mately five charge/discharge cycles.
You should not recharge a battery after brief usage
(e.g., 3 minutes) in order to protect it.
3 609 929 879 • (03.02) T
9.6 Angled Drive Heads
... 373 Order number 0 607 453 ...
8 Weight approx.
[V] 9.6
[Ah] 1.7
[kg] 0.4

4 OPERATING INSTRUCTIONS

English–5
8
... 644 ... 639
[Nm] 8
-1
[min ] 420
[V] 9.6
s 1/4"
q
q
[kg] 1.7
Inserting the Battery
Press the right/left switch 14 to the middle position to
activate the switch-on lock and place the on/off switch
13 in the "off" position. This prevents the unintentional
switching on of the tool.
Slide the charged battery 11 from below into the han-
dle of the power tool. Take care that the battery is in
the correct position when sliding in and that it can be
felt to engage in the handle.
Attaching the Insertion Tool
Type 0 602 490 635 / ... 636 / ... 637 / ... 638
Press in the pin on the drive square of the tool holder
2, e.g., with the aid of a small screwdriver and slide the
insertion tool 1 over the drive square. Take care that
the pin engages in the recess of the insertion tool.
Type 0 602 490 639 / ... 640
Insert the insertion tool 1 into the hex-socket of the
tool holder 2 until it can be felt to engage.
Removing the Insertion Tool
Type 0 602 490 635 / ... 636 / ... 637 / ... 638
Press in the pin in the recess of the insertion tool 1 and
pull the insertion tool off of the tool holder 2.
6 6
... 640 ... 641
6 6
650 650 650
9.6 9.6 9.6
s 1/4"
1/4" 1/4"
q
–
q q
1.2 1.7 1.2
s 1/4" s 3/8"
... 617 ... 620
[kg] 0.2 0.2
6 6
... 642
6 6
650
9.6
s 1/4"
q
–
q q
1.7
1/4"
... 618
0.2