SunStar Fortuna 5 Series User Manual page 60

No.
40 Checks operation of B/T solenoid
41 Checks operation of P/F solenoid
42 Checks operation of T/T solenoid
43 Checks operation of W/P solenoid
44 Checks operation of T/R solenoid
45 Checks operation of left solenoid
46 Checks operation of right solenoid
47 Checks operation of Aux. solenoid
48 Checks operation of Left LED solenoid
49 Checks operation of Right LED solenoid
50 Checks operation of needle when signal notifies up stop
51 Checks operation of needle when signal notifies down stop (OUTPUT13)
52 Checks operation of signal notifying motor running
53 Checks operation signal notifying target speed has been reached (OUTPUT15)
Select [Thread trimming sequence]
- The default is set to '0'. If you wish to input another sequence apart
54 from the thread trimming sequence provided in
the system input the newly composed sequence number.
(Refer to the sequence composition method)
55 Thread trimming sequence data writing function
Selecting sewing machine model
- write the number that fits the sewing machine model provided in
the full function manual..
- thread trimming sequence in the pertinent machine is copied.
56
- if you want to correct the thread trimming sequence, change
the contents of item B-55. (※However, be aware that if you initialize
the parameter, the newly programmed changes will disappear and
the thread trimming sequence will change to that of [SunStar 235/250]).
57 Independent operation of trimming sequence
Presser foot-lift solenoid slowing down time #1
58
(Applied only when it is full-on condition)
Presser foot-lift solenoid slowing down time #2
59
(Applied only when it is PWM)
※ Items No. 40~53 : functions that check if solenoid and other output signals are working properly.
※ Select Item No. 55 and press the Enter key. Along with the buzzer sound you will see the words "Seq 55" appear on the screen.
Thread trimming sequence composition permitting condition is now possible. You can program a thread trimming sequence to a
maximum of 64 bytes. (For thread trimming sequence program method, refer to attached material).
If the specific items of the parameter are changed carelessly, they could break down or damage the machine, so the
user must be well-trained before using it.
Caution
60
Function
(OUTPUT00)
(OUTPUT01)
(OUTPUT02)
(OUTPUT03)
(OUTPUT04)
(OUTPUT05)
(OUTPUT06)
(OUTPUT07)
(OUTPUT10)
(OUTPUT11)
(OUTPUT12)
(OUTPUT14)
Initial value Range
※After matching the number of the solenoid being
tested, press the "+1stitch(
in case of simplified
operation) and check the condition of the
movement.
- Along with the output, it will say "on" , or "off"
0 0~64
0 0~127
0 0/1
40ms 2~510ms
30ms 2~510ms
Step
)" key(button
1
1
0~ 74
(non-order made)
75~118
(order-made)
(Refer to attached material)
0=operation after trimming
1=independent operation
2ms
2ms