Juniper SRX5800 Getting Started Manual page 16

Figure 8: Connect Network Cables
4. Arrange the cable in the cable management system to prevent it from dislodging or developing stress
points. Secure the cable so that it is not supporting its own weight as it hangs to the floor. Place excess
cable out of the way in a neatly coiled loop in the cable management system. Placing fasteners on the
loop helps to maintain its shape.
CAUTION:
arc smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.
CAUTION:
the fastened loops of a cable to dangle, which stresses the cable at the fastening point.
Proceed to "Step 6: Connect Power Cables" on page
Avoid bending a fiber-optic cable beyond its minimum bend radius. An
Do not let fiber-optic cables hang free from the connector. Do not allow
17.
16