Installation; Before You Begin - Hochiki FireNET L@titude Series Information Manual

INSTALLATION

This section explains the installation procedure for the L@titude Network Vision Annunciator. Install this product
in accordance with NFPA 72, the National Electrical Code, and all local codes.
Notify the monitoring center and location security that the FireNET L@titude Fire Alarm Control Panel will be
q
temporarily out of service.
q
Remove the Annunciator from its packaging and check its contents.
q
Remove the fascia.
q
Mount the enclosure to wall.
q
Reinstall the fascia.
Remove AC and battery power from the panel.
q
WARNING!
warranty.
q
Connect field wiring. Refer to
q
Restore AC and battery power.
Wait for the panel start-up process to complete. Refer to the FireNET L@titude Fire Alarm Control Panel
q
Installation Manual (MAN-1431HA) for more information.
q
From the Annunciator GUI, set the node number. This requires User Access Level 3.
q
Configure the Annunciator and all nodes on the network.
q
Test the Annunciator to verify proper operation based on the configuration.
WARNING! The Annunciator must be installed by personnel familiar with electronic components. Electronic
components within the module are vulnerable to damage from electrostatic discharge. Ground straps must be worn by
installers before handling to prevent electrostatic discharge damage.

Before You Begin

Before you begin the installation, take a few minutes to review the installation information, gather the required
items, and complete the tasks listed to make the installation as quick and easy as possible. Acquire the following
item(s) that are not included, but may be required for installation:
Hochiki America Corporation
FireNET L@titude Network Vision Annunciator Information
Guide
Failure to remove power during wiring and installation can damage the unit and void the
Wiring below for specific details.
Version 1.03 | May 2019 | MAN-1434HA
Installation
Page 10