Table of Contents
Advertisement
Watch Sensors
A watch sensor is a precision instrument. Never try to take it apart. Never
●
try to insert any objects into the openings of a sensor, and take care to
ensure that dirt, dust, or other foreign matter does not get into it. After using
your watch where it has been immersed in saltwater, rinse it thoroughly with
fresh water.
Metal Components
Failure to clean dirt from metal components can lead to formation of rust,
●
even if components are stainless steel or plated. If metal components
exposed to sweat or water, wipe thoroughly with a soft, absorbent cloth and
then place the watch in a well-ventilated location to dry.
Use a soft toothbrush or similar tool to scrub the metal with a weak solution
●
of water and a mild neutral detergent, or with soapy water. Next, rinse with
water to remove all remaining detergent and then wipe dry with a soft
absorbent cloth. When washing the band, wrap the watch case with kitchen
plastic wrap so it does not come into contact with the detergent or soap.
Display Panel
Display figures may be difficult to read when viewed from an angle.
●
The display panel of this watch has flat bottom, and so it is not round.
●
Because of this using a watch face that is designed for a round display may
result in some part of the face being cut off.
The display panel of this watch uses high-precision technology that
●
provides a pixel yield in excess of 99.99%. This means that some very small
number of pixels may not light or may remain lit at all times. This is due to
the characteristics of the display panel, and does not indicate malfunction.
EN-116
Hide quick links:
Advertisement
Table of Contents
