Troubleshooting - Pari SOLE N Instructions For Use Manual

5 TROUBLESHOOTING

Fault table
Fault
The PARI SOLE N
does not heat up.
No medication is
coming out of the
nebuliser.
The nebuliser is
leaking.
In the event of faults that ...
In the event of faults that are not listed in this chapter, or if the suggested procedure
does not correct the fault, contact the PARI GmbH Service Center [See also: 7.4 Con-
tact].
- 46 -
Possible cause
The power cord is not plugged
into the power adapter properly.
The power plug is not plugged into
the mains socket properly.
The nebuliser nozzle is blocked.
The connection tubing is not con-
nected properly.
The connection tubing is leaking. Replace the connection tubing.
A gasket is damaged.
Procedure
Check that the power cord is
seated correctly in the power
adapter power cord socket.
Check that the power plug is
seated correctly in the mains
socket.
Clean the nozzle [See also: 4.5
What should I do if ...].
Check that both ends of the tubing
are seated properly.
Replace with a new set of gaskets
[See also: 4.5 What should I do if
...].