Cellink BIO X Installation And Quick Start Manual page 13

Enabling automatic calibration for a print
WARNING. Do NOT leave BIO X unsupervised while it runs automatic calibration. Be
prepared to unplug BIO X in the event of automatic calibration failure. Leaving BIO X
unsupervised during the automatic calibration process risks damage to your machine.
NOTE: Automatic calibration is only supported for the 3cc Pneumatic, 10cc Pneumatic and
Temperature-controlled Printheads.
HeartOS 1.7+:
Bioprint-> Print -> Print -> Calibrate -> Automatic Calibration
1. If you would like to run automatic bed-leveling and X, Y and Z axis calibration, start the
bioprinting process as usual. Select a model and a surface and enter your printer and
layer settings.
2. Go to the Print tab. Review your parameters and optionally save the protocol.
3. Select Print.
4. Press Calibrate in the print page. Select Automatic calibration.
Boston, U.S. Gothenburg, Sweden
Arvid Wallgrens Backe 20,
100 Franklin St.，
Gothenburg, 41346
Boston, MA 02110
Virginia, U.S.
2000 Kraft Dr., Suite 2125
Blacksburg, VA 24060
www.cellink.com | +1 (833) CELLINK
Kyoto, Japan
46-29 Yoshida-Shimo Adachi-
cho, Sakyo-ku, Kyoto
13