Battery Installation; Remote Control - Lenoxx CD114BL Instruction Manual

BATTERY INSTALLATION

The battery compartment is located on the back of the remote control.
1. Remove the battery compartment cover by pressing in on the tab and lifting it off.
2. Insert two (2) AAA size batteries (not included) into the battery compartment following the polarity
markings inside the battery compartment.
3. Replace the battery compartment cover.
Battery precautions:
Replacement of batteries must be done by an adult.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
The supply terminals are not to be short circuited.
Non-rechargeable batteries are not to be recharged.

REMOTE CONTROL

1) OPEN/CLOSE
2) INFO
3) REC
4) REP/INTRO/RAN
5) PROGRAM
6) PLAY/PAUSE
7) SKIP/SEARCH FORWARD
SKIP/SEARCH BACKWARD
8) STOP
9) FOLDER UP /DOWN
10) SOURCE
11) TRACK SEPARATION
PRESS TO OPEN OR CLOSE THE CD DOOR
PRESS TO SELECT ENCODING BITRATE
PRESS TO ACTIVE ENCODING OR
RECRRDING FUNCTION
IN SD/USB MODE, PRESS TO ACTIVE REPEAT /
INTRO / RANDOM FUNCTION
IN SD/USB MODE, PRESS TO ACTIVE
PROGRAMMING FUNCTION
IN SD/USB MODE, PRESS ONCE TO START
PLAYBACK. PRESS AGAIN TO ENTER PAUSE
MODE.
PRESS ONCE TO SKIP TO NEXT TRACK,
PRESS & HOLD FOR SEARCH FORWARD
PRESS ONCE TO SKIP TO PREVIOUS
TACK.PRESS & HOLD FOR SEARCH
BACKWARD
IN SD/USB MODE, PRESS TO STOP PLAYBACK
OR CANCEL THE STORED PROGRAM.
IN SD/USB MODE, PRESS TO SELECT FOLDER
UP OR DOWN
IN SD/USB MODE, PRESS TO SELECT SD OR USB MODE REPEATLY
PRESS TO DIVIDE THE RECORDING TRACK AT TURNTABLE OR TAPE ONE
BY ONE DURING ENCODING
3