Operation is subject to the following two conditions: • This device may not cause harmful interference, • This device must accept any interference received, including interference that may cause undesired operation. FCC ID: ESV-0117-1 Canada: 1249 102 643 Bosch Security Systems | 9/19 | 34453D...
Page 3
LED on a receiver not illuminating), try the test again. If there is still no confirmation, take the transmitter to the security department. 1 - Test button 2 - Alarm button 3 - Lanyard Bosch Security Systems | 9/19 | 34453D...
Page 4
The clip is designed to wear on a security type utility belt. If worn on a thin belt, be aware that such a loose fitting can cause the transmitter to activate the man-down alarm (if enabled) when there is too much loose movement. Bosch Security Systems | 9/19 | 34453D...
* SE2M is only used for system testing and does not generate a system alarm. Before distributing the attached User Guide, place an “X” in the box next to each feature enabled on the transmitter. 1 - Retaining screw 2 - Pry here Bosch Security Systems | 9/19 | 34453D...
Page 6
The transmitter uses a CR2, 3 V lithium battery. The central console indicates when the battery is low and needs replacement. See Figure 4 for battery polarity. The battery life depends on usage and enabled features. Bosch Security Systems | 9/19 | 34453D...
Page 7
SE2 Series | User Guide & Setup Instructions | 2.0 Part II - Setup Instructions EN | 7 Notes: Bosch Security Systems | 9/19 | 34453D...