Models And Features; Removing The Cover - Bosch Security Systems SE2 Series User Manual & Setup Instructions

SE2 Series | User Guide & Setup Instructions |
2.0 Part II - Setup Instructions
(For Security Department Use Only)
2.1

Models and Features

The various SE2 models and their features are identified
in Table 2.
Table 1: SE2 Models and Features
Model
Feature SE2S SE2U
Man-Down
Supervision
Tracking
Lanyard
Snatch
Auto
Tracking
Silent
Manual
Alarm
Low Battery
Indication
* SE2M is only used for system testing and does not generate a system
alarm.
Before distributing the attached User Guide,
place an "X" in the box next to each feature
enabled on the transmitter.
Bosch Security Systems | 9/19 | 34453D
2.0 Part II - Setup Instructions
SE2M* SE2S-SN SE2U-SN
2.2

Removing the Cover

The Man-Down, Supervision Tracking, and Lanyard
Snatch features are controlled by the jumpers located
next to the battery compartment.
To remove the cover:
1. Remove the belt clip (if used).
2. Remove the retaining screw on the back of the
enclosure (see Figure 3).
3. Using a flat-head screwdriver, pry the lower part of
the front cover away from the rest of the enclosure.
Figure 3: Back of Transmitter
1
1 - Retaining screw
2 - Pry here
EN | 5
2