Advertisement
SE2 Series | User Guide & Setup Instructions | 1.0 Part I - User Guide
1.2.2
Optional Features
Man-Down Alarm Feature
With the man-down feature enabled, the transmitter
alarms whenever the transmitter (you) is in a prone
position (60° from upright). The transmitter emits an
audible tone upon sensing the prone position, and
initiates the auto tracking feature. To reset the
transmitter after a man-down alarm is initiated, return
the transmitter to the upright position and perform a test
as described in Section 1.2.1 Standard Operation.
Lanyard Snatch Alarm Feature
With the lanyard snatch alarm feature enabled, the
transmitter sends an alarm signal to the central console
and initiates the auto tracking feature when the lanyard
pin is pulled out of the unit. To reset the transmitter
after a lanyard snatch alarm is initiated, reinsert the
lanyard pin and perform a test as described in Section
1.2.1 Standard Operation.
1.2.3
Wearing the Transmitter
The transmitter comes with a clip which can be worn
over a pocket or belt, or be secured to a belt. Secure the
clip to the transmitter (screws provided) at the two top
positions to use it as a clip.
To use the clip securely on a belt, attach it at the third
location at the bottom. Use the screw already securing
the battery door.
The clip is designed to wear on a security type utility
belt. If worn on a thin belt, be aware that such a loose
fitting can cause the transmitter to activate the
man-down alarm (if enabled) when there is too much
loose movement.
Bosch Security Systems | 9/19 | 34453D
Figure 2: Belt Clip Attachment
3
4
1 - Must use
2 - Optional
3 - Side view of clip
4 - Clip
5 - Back of transmitter
EN | 4
1
2
5
Advertisement
