Panasonic U-16GE2E5 Test Run Manual page 52

Displays
● Operation lamp: Lights up during operation. It blinks when an error occurs or a protective device is activated.
● Automatic cooling/heating, heating, drying, cooling, air blowing: Displays the mode set with the operation selection button.
● Temperature setting: Displays the temperature set by the temperature setting button.
● Automatic air velocity, extreme, strong, weak: Displays the air velocity set by the air velocity change button.
● Air direction: Displays the position of the fl ap.
● Swing: Displayed during swing operation.
● Unit No.: Displays the system (outdoor unit) address and indoor unit address of the indoor unit set by the unit selection button.
● Centralized control: Displayed during remote operation.
● Preparing for heating: When displayed, the indoor unit fan is stopped or on very low speed.
● Operation mode change control: When "Operation mode change control" lights up after using the operation mode
change button, it means that changing HEAT/COOL mode is prohibited.
● Filter: This is to inform you that it is time to clean the fi lter.
● Oil: Indicates that it is time to change the engine oil.
● Time display: Displays the time of the timer. (displays a warning in case of an error)
● Setting: A display indicating that the timer is set.
● Inspection: Displayed when the protection device is operating or when there is an error.
● Remote controller sensor: Displayed when the remote controller temperature sensor is being used.
● Test run: Displayed during a test run.
● Operation preparation: Displayed for stopped units in order of priority.
II - 44