● Auto fl ap
(This is not available for the perimeter type, built-in type, ceiling embedded type, outdoor air processing unit with
direct-expansion coil, and water heat exchanger unit.)
button
· When multiple units are connected, this is used for selecting the unit for adjusting the air direction. (during
group control)
· The air direction can be adjusted for each unit.
button
· For changing the fl ap angle.
· Each time this button is pressed, the fl ap angle is changed.
· When the fl ap is set at the lowest setting, if the button pressed once more the fl ap moves up and down, and
"
" is displayed on the remote controller.
· On wall mounted or fl oor mounted types, press once and the fl ap swings, press once more and it stops.
● Time
Each time the
or
The upper limit is 72 hours, the lower limit is 0.5 hours.
●
button
At the set time timer operation starts.
●
button
Stops the timer operation.
●
button
This is the fi lter reset button.
This is used to turn off the fi lter sign when it is lighting. (Use after cleaning the fi lter.)
●
button
When the inspection indication appears on the remote controller, the remote controller can be reset by turning it
off, and then turning it back on again after approximately 4 seconds. If the same warning appears again after op-
eration is resumed, stop operation, turn off the power switch, and close the fuel gas cock, and then make a request
for repairs to the dealer where you purchased the system or the service company.
button is pressed, the time increases or decreases by 0.5 hours.
II - 43