Checking the initial values
Check the initial values of the outdoor unit
Press the HOME (S004) key for longer than 1 second, and the menu item number will be displayed. " " (If
the STOP SW (S001) is on total stop, then after displaying " ", " " will be displayed)
Next, press the UP (S005) or DOWN (S006) key to display menu item number " ".
After displaying " ", " " is displayed. While " " is displayed press the SET (S007) key.
This displays the system address setting. (Example : " ")
In this condition use the UP (S005) or DOWN (S006) key to select the system address setting, outdoor unit ad-
dress setting, number of outdoor units connected setting, number of indoor units connected setting, type setting,
gas type setting and automatic address startup, etc.
Display
↑DOWN
↓UP
Generator settings
0
Unset
1
Generator available: Generation permitted
2
Generator available: Generation not permitted
3
No generator available
System address setting
Outdoor unit address setting
(Only change this when connecting multiple W MULTI outdoor units.)
Number of outdoor units connected setting
(Only change this when connecting multiple W MULTI outdoor units.)
Number of indoor units connected setting
Capacity setting (cannot be set)
Gas type setting
Refrigerant setting (do not change)
Generator setting
Engine setting
Model 1 setting
Model 2 setting
Destination setting
N/P judgment setting
Hot water temperature setting
Oil replacement time indication setting
Single phase setting
Compressor setting
Heating automatic address setting
Cooling automatic address setting
II - 15
Function