Panasonic U-16GE2E5 Test Run Manual page 37

(4) Changing the indoor unit address (when necessary)
• All changing operations are carried out from a wired remote controller.
• This operation is carried out when you want to change the indoor unit ad-
dress after it has been set automatically.
• It is not possible to change the system address.
Remote controller
Changing the address of indoor units under individual and group control
This change is carried out with the indoor units not operating.
Press the button, the
longer than 4 seconds. "Unit No.
main unit is fi rst displayed) and "Setting data
fl ickering.
Press the
For group control, select the indoor unit address to change. (Example: For
the number 1-1 unit, "Unit No. - ")
The fan of the selected indoor unit starts to operate.
With the temperature setting
  " to "Item code  ."
With the time setting
change the address.
Note: For an individual remote controller, if the address is duplicated the
error message "    " is displayed, but it is possible to continue
changing the address.
The error message disappears when the duplication is removed.
Press the button.
The remote controller display changes from fl ickering to lit up.
For group control, using the
address to change. Repeat the operations
address so as not to cause any duplication.
Note: For group control it is not possible to correct it if there is duplica-
tion. In that case re-do the automatic addressing operation.
After completion of the changes, press the
each indoor address. (The unit No.
check the setting data using the fan of the indoor unit.)
After completion of the checks press the
of the remote controller is restored.
button, and the
- " (in the case of group control the
button.
or
or button, set "Setting data" to the number to
button, select the next indoor unit
- is the value before changing, so
button simultaneously for
" are displayed as
button, change "Item code
- , changing the indoor unit
button and re-check
button. The normal display
II - 29