Piggy Back For Iec Motor Size 225 And Above - Siemens MOTOX BA 2010 Operating Instructions Manual

Installation
3.6 Adjusting the height of the piggy back
3.6.4

Piggy back for IEC motor size 225 and above

NOTICE
When tightening the hexagon nuts 592, do not distort or force the motor plate 590 into a
different position
515
585
586
588
589
590
592
Figure 3-10
Procedure
1. Loosen the grub screws 585.
2. Loosen the hexagon nuts 592 on the support.
3. Adjust the height of the motor plate 590 by evenly turning the bolt 588.
4. After setting the correct height, tighten the grub screws 585.
5. Tighten the hexagon nuts 592 on the support.
You have now mounted the piggy back for IEC motors size 225 and above.
30
Drive shaft
Grub screw
Column
Screw
Hexagon nut
Motor plate
Hexagon nut
Piggy back for IEC motor size 225 and above
Operating Instructions, 08/2018, A5E38094087A/RS-AE
BA 2019