Table of Contents
Advertisement
Service and maintenance
5.2 Regreasing the roller bearing
5.2
Regreasing the roller bearing
NOTICE
When regreasing do not mix greases with different soap bases
Drive units of motor size 160 and above need to be regreased for K2, A and P and drive
units of motor size 225 and above need to be regreased for K4. The input units in these
sizes are equipped with a grease nipple.
Regrease at least every 12 months or every 4 000 operating hours.
The bearings are supplied greased.
The standard lubricating grease used is a mineral-oil-based lithium-saponified grease of
NLGI class 3/2.
Figure 5-1
Using a grease gun, inject the grease into the bearing point via the lubricating nipples
provided. Inject 50 g grease per lubricating point, unless otherwise specified in the vicinity of
the lubricating point.
34
Grease nipple
Operating Instructions, 08/2018, A5E38094087A/RS-AE
BA 2019
Advertisement
Table of Contents
